Knowledge

Packaging terms-Metal containers(4)

5 metal cans


5.1 three-piece can


A metal can made by connecting the lid, the bottom and the body of the can respectively. 


5.2 two-piece can


The can bottom and can body are formed by stamping and drawing from a whole metal sheet, and then the can body and the can lid are connected to form a metal can. See Figure 8.


5.3 composite can


The can body, the bottom of the can, and the lid of the can are composed of different materials.


5.4 round can


A metal can in the shape of a cylinder. If the tank diameter is smaller than the tank height, it is called a vertical round tank, and if the tank diameter is larger than the tank height, it is called a flat round tank. See Figure 9.


5.5 Irregular can


A general term for metal cans with a non-cylindrical shape.


5.6 rectangular can


Metal cans with square or rectangular cross-sections and rounded corners. 


5.7 obround can


Its cross-section is a metal can with parallel sides, and both ends are connected by half arcs. See Figure 11.


5.8 oval can


Metal cans with oval cross-sections.


5.9 trapezoidal can


The top and bottom are rounded rectangles of different sizes, and the longitudinal section is approximately a trapezoidal metal can. See Figure 13.


5.10 pear can


The cross-section is a rounded metal can with an approximate isosceles triangle.


You Might Also Like

Send Inquiry