Knowledge

Packaging terms-Metal containers(5)

5.11 Step-side can


The top section of the can body is increased to accommodate metal cans with larger lids. See Figure 14.


5.12 necked-in can


One or both ends of the can body are reduced in cross-section to accommodate metal cans with smaller lids or bottoms.


5.13 hermetically sealed can


A sealed and airtight metal can which can prevent the invasion of microorganisms, make the sterilized contents meet the hygienic requirements, or make the contents unaffected by the outside air and moisture.


5.14 drawn can


For two-piece cans manufactured by shallow drawing, the ratio of can height to can diameter is less than 1.


5.15 deep drawn can, drawn and red drawn can


For a two-piece can manufactured by a multi-stage stretching method, the ratio of the can height to the can diameter is greater than 1.


5.16 drawn and ironed can


The bottom of the can and the body of the can are integrally formed into two-piece cans by stretching and thinning the can wall. Mostly aluminum.


5.17 soldered can


The three-piece cans are welded with tin or tin-lead alloy where the steel plates are hooked together at the seam of the can body.


5.18 resistance welding can


The three-piece cans are welded with a resistance welding machine by overlapping the steel plates at the joints of the can body.


5.19 laser welded can


Three-piece cans are welded with steel plates at the joints of the can body and are welded by laser.


5.20 cono-weld can


A three-piece can made of nylon and other adhesives at the seam of the can body. Mostly made of Wuxi iron sheet (TFS).


You Might Also Like

Send Inquiry