Knowledge

Packaging terms-Metal containers(18)

9.21 juncture rating


It refers to the phenomenon that the width of the cover hook formed by the cover hook at the seam of the can body is insufficient when the edge is rolled. The ratio of the effective lid hook to the entire lid hook width was observed after dissection of the double hemming.


9.22 lock side


A four-layer folded seam formed by hooking the ends of a barrel or can body to each other. See Figure 37.


9.23 lap side seam


The two ends of the barrel or can body are stacked together to seal the seam formed by brazing or welding. See Figure 36.


9.24 Butt-welded side seam


The seam formed by welding the edges of the two ends of the barrel or tank body together.


9.25 sealing


After the contents are put into the packaging container, the operation of sealing the opening of the container.


9.26 hermetic sealing


After the container is sealed, it is a closed form that does not leak gas at the seal.


9.27 liquid sealing


After the container is sealed, the sealing form does not leak liquid.


9.28 tight sealing


After the container is sealed, it is a closed form that does not leak solids at the seal.


9.29 slitting


The process of cutting the whole or coiled metal sheet into small pieces of barrel or can body that meet the requirements of barrel or can making, or a strip bottom cover that can be used for punching the bottom cover.


9.30 Cylinder forming


The process of rolling the barrel or can body into a cylindrical shape with a round roller.


You Might Also Like

Send Inquiry