Knowledge

  • 11

    Jul-2022

    Packaging terms-Metal containers(9)

    6 Metal Spray Containers 6.1 Aerosol can A single-use metal container for holding aerosol products. The aerosol products pass through the valve under the action of pre-pressure and

  • 08

    Jul-2022

    Packaging terms-Metal containers(8)

    5.41 Notching In the manufacturing process of tin soldering cans, one end of the can body plate is cut off, and the other end is cut into two acute angles, so that when the can bod

  • 07

    Jul-2022

    Packaging terms-Metal containers(7)

    5.31 Tank can without lid Three-piece jar without lid. 5.32 ring It is fixed on the top of the can body by double crimping, and there is an opening in the center to install the com

  • 06

    Jul-2022

    Packaging terms-Metal containers(6)

    5.21 easy open can Airtight jar with easy-open lid. 5.22 key open can A metal can that is pre-scored on the top with tongue tabs, rolled with a can opener. See Figure 16. 5.23 alum

  • 01

    Jul-2022

    Packaging terms-Metal containers(5)

    5.11 Step-side can The top section of the can body is increased to accommodate metal cans with larger lids. See Figure 14. 5.12 necked-in can One or both ends of the can body are r

  • 30

    Jun-2022

    Packaging terms-Metal containers(4)

    5 metal cans 5.1 three-piece can A metal can made by connecting the lid, the bottom and the body of the can respectively. 5.2 two-piece can The can bottom and can body are formed b

  • 27

    Jun-2022

    Packaging terms-Metal containers(3)

    4.12 filling hole A hole on the top of the barrel for filling or draining the contents. 4.13 Air vent air-vent A hole on the top of the bucket for ventilation when filling or disch

  • 23

    Jun-2022

    Packaging terms-Metal containers(2)

    4 metal buckets 4.1 Removable head drum A metal bucket with a removable top, the top of which is the top cover of the fully-opened bucket, is usually fixed by a closing hoop, clip,

  • 17

    Jun-2022

    Packaging terms-Metal containers(1)

    1 Subject content and scope of application This standard specifies the terms and definitions of metal packaging containers and their materials and technologies. This standard appli

  • 07

    Jun-2022

    Technology of printing Iron:Classification and technological process of iron ...

    There are two types of ironworkers: painted ironworkers and colored ironworkers. 1. Iron coating: It is to apply a layer of paint called 214 on the inner layer of the iron sheet fo

  • 06

    Jun-2022

    Technology of printing Iron:Special structure of printing equipment

    Due to the different substrates, the auxiliary mechanism of the tinplate printing press is also different from that of the printing paper offset press. Tinplate is insoluble in wat

  • 02

    Jun-2022

    Technology of printing Iron:Ink drying process

    In the production of tinplate printing, the drying of ink is a complex physical and chemical reaction process. It is necessary to reasonably control the drying speed of ink and mas